WILSON ANCHOR BOLT SLEEVES
WILSON ANCHOR BOLT SLEEVES are  the cost effective solution to anchor bolt alignment problems.  The Wilson
Anchor Bolt Sleeve has been specified by engineers for use in nuclear power plants, paper plants, and large
manufacturing facilities.
Wilson Anchor Bolt Sleeves allow equipment and structural bolts to be installed correctly without risk of removing
misaligned bolts.  In a high density polyethlene, sizes range from 1/2" to 5" diameter and lengths from 5" to 24".  The
basic use is as an in-place form to provide a grout pocket around an anchor bolt, (Figures 1 and 3) and is used to
form a pocket into which a bolt may be grouted (Figure 2).  May also be used where metal pipe is objectionable due to
rusting or cost, and in food processing areas due to the inert polyethlene.
No Custom Pre-fitting.  No Flame Cutting.  No Bent Bolts.  No Broken Bolts.
FIGURE 1
FIGURE 2
FIGURE 3
BOLT DIAMETER
SLEEVE O.D. AND LENGTH
CARTON QTY
1/2
2" x 5"
100
3/4
 2" x 5"
100
5/8
2" x 7"
90
3/4
2" x 7"
90
7/8
2" x 7"
90
1"
3" x 10"
35
1-1/4
3" x 10"
35
1-1/2
4" x 15"
12
1-3/4
4" x 15"
12
2"
4" x 18"
9
2-1/4
4" x 18"
9
2-1/2
6" x 24"
4
3"
6" x 24"
4
4"
 6" x 24"
4
5"
 6" x 24"
4
Less Than Full Carton Quantities May Be Available